SAM4S ELLIX 20 II DRIVER DOWNLOAD

Control Commands Chapter 5. Setting Up The Printer Chapter 1. Connecting The Power Supply Do not use paper rolls that have the paper glued to the core because the printer cannot detect the paper end correctly. Page 56 JKA Rev. They are all connected to the connector panel on the back of the printer, which is shown as below:

Uploader: Akinolar
Date Added: 3 September 2008
File Size: 69.10 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67470
Price: Free* [*Free Regsitration Required]

Page 31 Page Space Page – 28 Do not use paper rolls that have the paper glued to the core because the printer cannot detect the paper end correctly. Printer Head Cleaning D. Don’t show me this message again.

By pressing ‘print’ button you will print only current page. Recovery from the Auto Cutter Error If a foreign object, for example a paper clip drops in the auto cutter and causes the auto cutter to lock up, the printer will error.

Sam4s ELLIX 20 Operator’s Manual

Using an improper drawer may damage the drawer as well as the printer. To print the manual completely, please, download it.

Recent Drivers  C7250 DRIVERS FOR WINDOWS 7

Using an incorrect power supply may cause fire or electrical shock. Setting Up the Printer Printer Head Cleaning Paper dust on the heating elements may lower the printing quality.

You can change the setting to adjustment scale 1,2,3,4 and 5 as described below.

SAM4s Ellix II Two Color Thermal Receipt Printer – Mojitech

Enter text from picture: Push the Open-Button and open the Cover-Open. It does, however, offer some settings for users with special requirements. In this case, clean the printer head as follows: Printing speed may be slower, depending on the data transmission speed and the combination of control commands.

Connecting The Drawer The Self Test Chapter 3. Wllix the printer lid is raised the serrated edge of the paper tear bar is also accessible, Care should be taken with the serrated edge. When you turn on the hexadecimal dump function, the printer prints all commands and data in hexadecimal format along with a guide section to help you find specific commands. They are all connected to the connector panel on the back of the printer, which is shown as below: Connecting The Power Supply Parallel Interface Specification The self test The self-test checks whether the printer has any problems.

Recent Drivers  BROADCOM 4311AG TREIBER WINDOWS 7

CRS | SAM4s Ellix II Two-Color Thermal Printers

Adjusting the roll paper Near-End sensor location This sensor has five settings, which are scale 1,2,3,4 and 5. Wall Mount Installation Turn on the power while holding down the FEED button. Connecting The Cables The Near-End sensor is set to 3 positions at the factory. Hexadecimal Dumping Chapter 2. Connecting the Power Supply Use the optional Power supply for your printer.

To find the character corresponding to a hexadecimal number, count across the top of the table for the left digit and count down the left column of the table for the right digit. The self-test checks are as follows; Make sure paper roll has been installed properly. Notice the position of the holes.